The following examples are installed with the Power Electronics Add-On. Select each example for a detailed description of its configuration parameters.
By default, the examples are located in this directory:
<Public Documents>\National Instruments\<NI VeriStand 20xx>\Examples\OPAL-RT\Power Electronics Add-On
1. Three Phase Rectifier
- 1.0 Opening the Example
- 1.1 Configuring the Real-Time Controller
- 1.2 Selecting a Hardware Configuration
- 1.3 Updating the Circuit Model
- 1.4 Configuring the Sources of the Model
- 1.5 Configuring the Switches of the Model
- 1.6 Setting Default Values for the Sinewave Generators
- 1.7 Configuring the Waveforms of the Simulation
- 1.8 Deploying and Running the Simulation
- 1.9 Controlling and Monitoring the Simulation
2. Two Level Inverter
- 2.0 Opening the Example
- 2.1 Configuring the Real-Time Controller
- 2.2 Selecting a Hardware Configuration
- 2.3 Updating the Circuit Model
- 2.4 Configuring the Sources of the Model
- 2.5 Configuring the Switches of the Model
- 2.6 Setting Default Values for the SPWM Generators
- 2.7 Configuring the Waveforms of the Simulation
- 2.8 Deploying and Running the Simulation
- 2.9 Controlling and Monitoring the Simulation
3. Dual PMSM VDQ Local Control
- 3.0 Opening the Example
- 3.1 Configuring the Real-Time Controller
- 3.2 Selecting the Hardware Configuration
- 3.3 Configuring the Electrical Models
- 3.4 Configuring the Sources of the Model
- 3.5 Configuring the Switches of the Model
- 3.6 Setting Default Values for the Signal Generators
- 3.7 Configuring the Waveforms of the Simulation
- 3.8 Configuring the Local Controller
- 3.9 Deploying and Running the Simulation
- 3.10 Controlling and Monitoring the Simulation
4. Dual PMSM SH Local Control
- 4.0 Opening the Example
- 4.1 Configuring the Real-Time Controller
- 4.2 Selecting the Hardware Configuration
- 4.3 Configuring the Electrical Models
- 4.4 Configuring the Sources of the Model
- 4.5 Configuring the Switches of the Model
- 4.6 Setting Default Values for the Signal Generators
- 4.7 Configuring the Waveforms of the Simulation
- 4.8 Configuring the Local Controller
- 4.9 Deploying and Running the Simulation
- 4.10 Controlling and Monitoring the Simulation
5. Quad SCIM Constant Local Control
- 5.0 Opening the Example
- 5.1 Configuring the Real-Time Controller
- 5.2 Selecting the Hardware Configuration
- 5.3 Configuring the Electrical Models
- 5.4 Configuring the Sources of the Model
- 5.5 Configuring the Switches of the Model
- 5.6 Setting Default Values for the SPWM Generators
- 5.7 Configuring the Waveforms of the Simulation
- 5.8 Configuring the Local Controller
- 5.9 Deploying and Running the Simulation
- 5.10 Controlling and Monitoring the Simulation