The face plate provides two HDB44 connectors (J1, J2), one 4-pin Molex connector (J3) and two LEDs:
J1, J2 Connectors
The 32 digital I/O signals are routed to both J1 and J2 connectors. This allows, for example, splitting the input and output signals into two different cables.
If the harnessing uses only one connector, it is recommended to use J2 (bottom one).
The connectors' pin assignment is detailed in OP8910 Pin assignment
J1-J2 Recommended mating connector
|Norcomp||180-001-170L001||Crimps for 24 to 26 wire gauge|
J3 is used to connect the two external reference voltages for fault insertion.
J3 Mating connector with crimps
|Molex||538-172258-1004||Headers and Wire Housings|
|Molex||538-172253-3023-LP||Crimps for 16 to 18 wire gauge|
|LED Name||LED Behavior||Definition of Behavior|
|Off||No power present on module (from SLSC Interface nor external power)|
|Solid Green||Power Good State|
|Blinking Red||Module Fault State|
|Off||Module is not powered or in Rdy/Rst# is driven low by the chassis.|
|Solid Green||Module in default configuration, recognized by the chassis and ready|
to configure (The Rdy/Rst# signal has been pulled high by the chassis.)
|Blinking Amber||Module is active (in a non-default configuration and/or communicating|
with the chassis).