- 32 optically isolated input
- All inputs are sampled simultaneously, at up to 1 Mb/s
- Inputs are read in parallel for any size bus
- Choice of sink or source inputs connection (anode and cathode side available).
- Minimum current input of 3.6 mA
- 5V to 30V input voltage
- 30V maximum reverse
The optically isolated inputs accept a wide input voltage range, from 5 to 30 Volts, according to user requirements. They have a low threshold current; typically 3.6 mA. Each input has reverse voltage protection of up to 30 Volts provided by a Schottky diode..
The schematic below represents the electrical circuit of one channel, from the Din+/Din- input signals coming for the unit under test (on the right) to the Din_FPGA signal going to the FPGA processor of the real-time simulator (on the left).
- When current flows from Din+ to Din-, the output of optocoupler (A) is low and the Din_FPGA signal is low.
- When no current flows, the optocoupler output (A) is high and the Din_FPGA signal is high.
- Both Din+ and Din- pins (anode and cathode sides) are routed to the DB37F connector of the simulator and made available to the user
The diagrams below illustrate typical application examples.
INTERFACE BETWEEN CMOS DRIVE AND OPAL-RT Din
- The maximum current is 3.6mA
Typical Use Cases
The circuit makes it possible to use the module for activation or open-circuit detection, both in the high or low active state.
Typical high side activation (user high Dout)
Typical low side activation (user low Dout)
Typical high side open circuit detection
Typical low side open circuit detection
The OP4250-1 cassette includes the OP5353-1 mezzanine card.