Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

OP7000 front connector panels

A: Power switch with LED

B: Carrier board (OP7220) interfaces:

  • 16 red LEDs (8 pairs). Light intensity is directly commensurate to voltage (the higher the voltage, the brighter the LED intensity)1.
  • One Status LED with variable color (see table for display description)
LEDDescription
RedInsufficient power voltage for digital board
Blinking redInsufficient power voltage for analog board
Blinking orangeNo mezzanine upload
OrangeSanity signal absent
YellowAll statuses normal
Blinking yellowError in analog board even slot
  • One column of 4 RJ45 connectors provide connections to monitor output from mezzanine I/O Each connector represents 4 channels (see OP7000 Installation and Configuration for more detailed information).


C: Monitoring connectors: See OP7000 Installation and Configuration for instructions on using these connectors.

D: OP7161 Front interface providing, from top to bottom :

  • Seven LED indicators :

Position

LED

Description

1

Power

On (green) indicates that the unit is powered up.

2

Config

Green indicates that a user-defined configuration (bitstream) is running. Yellow indicates that the safe, default configuration (bitstream) is running. Flashing indicates the configuration is paused.

Off indicates that there is no configuration available..

3

Comm

On (green) indicates communication with the PC is in progress.

4

Model

On indicates model in use.

5

Sync

Green indicates Master synchronization in progress Yellow indicates Slave synchronization in progress

6

Fault

Red indicates a fault.

7

User-defined

 Green/Yellow

  • One JTAG connector for programming functions. Reserved for OPAL-RT technicians’ use
  • One RJ45 connector. This connector is DISABLED.