Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

This procedure is required when attempting to deploy a Veristand project created in the 1.6.0 version of the Power Electronics Add-On, using the 1.6.x version of the Power Electronics Add-On, and when using the following hardware configurations of the Veristand Custom Device:

  • Dual_eHSx64_Quad_PMSM_VDQ_IO_Dual_7868R
  • eHSx64_Dual_PMSM_VDQ_IO_7868R
  • eHSx128_Dual_PMSM_SH_IO_7976R
  • eHSx128_Dual_PMSM_VDQ_IO_7976R
  1. Open the System Definition of the existing project.
  2. Browse through the System Definition Tree and expand the Mechanical Model section of each machine (PMSM VDQ or PMSM SH) in the hardware configuration.
  3. Click on the Mechanical Model page. Notice how the Electromagnetic Torque and the Electric Angle channels are included into the three after opening the Mechanical Model page.
  4. Make sure to complete the previous steps for each machine (PMSM VDQ or PMSM SH) in the hardware configuration.
  5. Save the System Definition.