Pour la documentation en FRANÇAIS, utilisez l’outil de traduction de votre navigateur Chrome, Edge ou Safari. Voir un exemple.

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »

The OP5700 simulator offers quick, single-ended connections, through RJ45 and mini BNC connectors, to any monitoring device (i.e. oscilloscope, etc.). These mini-BNC jacks let you monitor 4 channels individually. Simply follow these instructions (as illustrated in the following Figure):

The monitoring board has a gain of 0.1 to allow a broader range of signals to be read. Oscilloscopes must be adjusted with a gain of 10 to compensate and ensure accurate readings. Only connect RJ45 cables from the upper section (A) monitoring jacks to lower section monitoring panel (B, as shown). Connecting any other cable or device may result in damage to the equipment.

How to connect RJ45 cables for monitoring A.

A. Connect one end of the RJ45 cable to the desired channels (A). See for RJ45 connector pinouts

B. Connect the other end of the RJ45 cable to the monitoring connector (B)

C. Connect BNC cable connectors as shown in the figure below. These are labeled A, B, C, D and each connector represents a channel. 

Connecting BNC monitoring cables

Connect a mini-BNC cable to each jack (C) and connect the other end of the cable to the desired monitoring device.

  • No labels