The front section contains the carrier boards and conditioning modules with connectors for monitoring and the rear section contains conditioning boards for connections from the unit under test.
*The OP7161 and OP7461 boards are the core of the OP7000 and are not optional. Consult your sales representative for the complete list of available signal conditioning boards.
Boards used in the back of the unit must correspond to the type of boards used in the front.
Example: if an Analog Outboard is used in front slot #1, then a matching Analog outboard must be used in the rear slot #1.
Universal Carrier with OP5330 or OP5340 mezzanine card.
Required for use of back analog IO cards
OP7818 - 2
OP7000 Rear Analog Input conditioning for OP5340, Voltage or Current mode, 16ch DB37 connectors
OP7819 - 2
OP7000 Rear Analog Output conditioning for OP5330, Voltage or Current mode, 16ch DB37 connectors
OP7000_6U_AIO_Carrier_DB37 for Type E Modules (Max of 4 modules per carrier)
|Front Monitoring Interface|
OP7816 - 2
OP7000 Rear Opto-Isolated Digital Input: 16-Din DB37 connector
OP7817 - 2
OP7000 Rear Opto-Isolated 16-Dout, Push-Pull 5V to 30V, DB37 connector
Secondary V6 (240T) (slots 9, 11, 13 only). For distributed FPGA simulations
In most cases, the corresponding back IO card is driven by the Primary FPGA
OP7000 Rear 8TX and 8RX DC to 50 MBd Fiber Optic link, 650nm
OP7000_Rear_16Dout_SSR_250V_200mA (Normally Open Relay)
OP7000 Rear 16RX DC to 50 MBd Fiber Optic link, 650nm
OP7000 Rear_16TX_DC_to_50_MBd_Fiber_ Optic_link_650nm
Primary V6 (130T or 240T)
OP7000 Rear Synchronization card (Between OP7000, OP5600, Wanda, …)
Communication Interface PCIe 4X (match with 126-0347)
NOTE: For the OP7361, please see User Manuals of Former Products