The OP7816 (also named OP7816-2) module features 16 digital input signals.
The cards feature optical isolation of all the inputs.
The card accepts input voltages between 5V and 50V, with a 30V maximum reverse protection.
In the typical configuration, the 16 channels are routed via the mid-plane of the chassis to the Primary FPGA card (OP7161-1 or OP7170-1) which performs acquisition of the channels' state. Alternatively, if a Secondary FPGA card (OP7161-2 or OP7170_2) is installed in the front slot corresponding to the back slot where the card is installed, the acquisition of the channels can be performed by this secondary FPGA card.
The optically isolated inputs accept a wide input voltage range, from 5 to 50 volts. They are current limited to 3.6 mA. Each input has a reverse voltage protection of up to 30 volts provided by a diode.
The digital input circuit needs a 5 V supply source to power the onboard circuitry. In the case of the OP7816, this source is connected to the OP7000 chassis's 5 VDC source (not to the simulator as indicated on the figure below).
The signal conditioning module inputs have both anode and cathode sides available to the user (on the DB37F I/O connector).
When current flows from Din+ to Din -, the output of optocoupler A is low and the Din_FPGA signal is low. When no current flows, the optocoupler output A is high and the Din_FPGA signal is high.
The OP7816 digital input module must be inserted at the back of the OP7000 simulator. The card can be installed in any of the 16 back slots, provided the front slot configuration is compatible. Refer to the page OP7000V2 Adding or Replacing Boards for more information on digital I/O card placement in the chassis - the same applies to the OP7000 chassis.
Make sure that the board is properly aligned using the guide tracks before pressing it into place.
The faceplate provides the DB37F connector used to connect the 16 input signals.
OP7000 back 16 Din opto-isolated board
Number of channels
16 digital inputs
12 Vcc @ 1.5A
Maximum reverse voltage protection
0 to 5 Vcc or 5 to 50 Vcc
Delay Low-to-High (minimum)
≈ 40 ns
Delay High-to-Low (maximum
≈ 75 ns
18.8 x 16.4 cm (7.4 in x 6.46 in)
10 to 40 ºC (50 to 104ºF)
-55 to 85ºC (-67 to 185ºF)
10 to 90%, non condensing
2,000 m (6562 ft.)